Menu
Yeah Dale, it would seem to me that electrons are gonna flow from point A to
point B whether they're traveling through wire or the conducting material on a
circuit board and tone is not going to be affected unless different components
are used.
-Marty
----- Original Message -----
From: darklsurf
To:
Sent: Wednesday, December 01, 2004 7:09 AM
Subject: [SurfGuitar101] Point to Point?
Is there a big difference between hand built point to point and sqeezed out of
the
factory stamped circuit boards?
Other than the obvious being able to repair a point to point board, I've been
under
the school of thought that once a stamped circuit board was burned in and
"worked"
is was good to go. If a stamped circuit was bad, you'd know right away...well
hopefully anyway.
Of course there is the "tone" issue, but I haven't researched that as much.
Except for
my current amp, I've always had older point to point wiring. So honestly, I'm
not sold
on either case about tone.
I've been checking out some different amp options and thought I'd run it by
you all.
Thanks!
Dale
PS- No formulas please :)
.
Visit for archived messages,
bookmarks, files, polls, etc.
Yahoo! Groups Sponsor
ADVERTISEMENT
------------------------------------------------------------------------------
Yahoo! Groups Links
a.. To visit your group on the web, go to:
b.. To unsubscribe from this group, send an email to:
c.. Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.
[Non-text portions of this message have been removed]
